Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2011 Subaru Outback LimitedFACTORY OEM SERVICE PROCEDURE

Automatic Transmission Assembly: Installation

Attach the ST to converter case.
ST 498277200 STOPPER SET

Fig 1: Identifying Stopper Set On Converter Case
Courtesy of SUBARU OF AMERICA, INC.
When completely overhauling the transmission, refill approx. 10 l (2.6 US qt, 8.8 Imp qt) of CVTF through the transmission right side plug, and install the plug.
CAUTION: Always use specified CVTF or equivalent. Using other fluid than specified or equivalent will cause malfunction. Refer to , HYDRAULIC CONTROL AND LUBRICATION , SPECIFICATION, General Description.

Chapter Navigation

Return to Chapter: Automatic Transmission Assembly

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.