2011 Subaru Forester X, StandardFACTORY OEM SERVICE PROCEDURE

Fuel Injector: Removal

  1. Release the fuel pressure. < Ref. to RELEASING OF FUEL PRESSURE , PROCEDURE. >
  2. Disconnect the ground cable from battery.
    Fig 1: Disconnecting Ground Cable From Battery
    G07664744Courtesy of SUBARU OF AMERICA, INC.
  3. Open the fuel filler lid and remove the fuel filler cap.
  4. Remove the air intake boot. (RH side only) < Ref. to REMOVAL , Air Intake Boot. >
  5. Disconnect the connector (A) from the mass air flow and intake air temperature sensor, and remove the clip (B) which holds the mass air flow and intake air temperature sensor harness. (RH side only)
  6. Remove the suction hose (C) from the air cleaner case (rear). (RH side only)
    Fig 2: Mass Air Flow And Intake Air Temperature Sensor Connector And Suction Hose
    G07664745Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the air cleaner case (rear). (RH side only)
    Fig 3: Locating Air Cleaner Case Clamps
    G07664746Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the intake manifold protector.
    • LH side
      Fig 4: Locating Intake Manifold Protector Mounting Bolts
      G07664747Courtesy of SUBARU OF AMERICA, INC.
    • RH side
      Fig 5: Locating Intake Manifold Protector Mounting Bolt
      G07664748Courtesy of SUBARU OF AMERICA, INC.
  9. Disconnect the connectors (A) from fuel injector.
  10. Remove the bolts which hold fuel pipe onto the cam carrier.
    Fig 6: Locating Cam Carrier Mounting Bolts
    G07664749Courtesy of SUBARU OF AMERICA, INC.
  11. Remove the fuel injector.
    Fig 7: Removing Fuel Injector
    G07664750Courtesy of SUBARU OF AMERICA, INC.
Chapter Navigation
Return to Chapter: Fuel Injector
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.