2011 Subaru Forester X LimitedFACTORY OEM SERVICE PROCEDURE

Throttle Sensor (Method With Circuit Tester)

  1. Remove the glove box lower cover. < Ref. to REMOVAL , Glove Box. >
  2. Remove the lower inner trim of passenger's side. < Ref. to REMOVAL , Lower Inner Trim. >
  3. Turn over the floor mat of passenger's seat.
  4. Remove the protect cover.
    Fig 1: Locating Protect Cover Mounting Bolts
    G07664660Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the nuts and bolts which hold the ECM to the bracket.
    Fig 2: Locating ECM Bracket Nuts And Bolts
    G07664661Courtesy of SUBARU OF AMERICA, INC.
  6. Turn the ignition switch to ON. (engine OFF)
  7. Measure the voltage between ECM connector terminals.
    Fig 3: Measuring Voltage Between ECM Connector Terminals
    G07664662Courtesy of SUBARU OF AMERICA, INC.
    ECM CONNECTOR TERMINALS REFERENCE CHART

    Throttle sensor Accelerator pedal Terminal No. Standard
    Main Not depressed (Full closed) 18 (+) and 29 (-) Approx. 0.6 V
    Depressed (Full opened) Approx. 4.0 V
    Sub Not depressed (Full closed) 28 (+) and 29 (-) Approx. 1.5 V
    Depressed (Full opened) Approx. 4.2 V
  8. After inspection, install the related parts in the reverse order of removal.

    Tightening torque: 

    7.5 N.m (0.8 kgf-m, 5.5 ft-lb) 

Chapter Navigation
Return to Chapter: Inspection
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.