2011 Subaru Forester F4-2.5L DOHCFACTORY OEM SERVICE PROCEDURE

Ignition Timing: Testing and Inspection

Ignition Timing

INSPECTION

CAUTION:
After warming-up, engine becomes very hot. Be careful not to burn yourself at measurement.

METHOD WITH SUBARU SELECT MONITOR

1) Before checking the ignition timing, check the following item:
(1) Check the air cleaner element is free from clogging, spark plugs are in good condition, and hoses are connected properly.
(2) Check the malfunction indicator light does not illuminate.
2) Warm up the engine.
3) Read the ignition timing using Subaru Select Monitor.

NOTE:
If ignition timing is out of standard, check the ignition control system.

Ignition timing [BTDC/rpm]:
Standard
16°±10°/675 (AT model)
16°±10°/650 (MT model)

METHOD WITH TIMING LIGHT

1) Before checking the ignition timing, check the following item:
(1) Check the air cleaner element is free from clogging, spark plugs are in good condition, and hoses are connected properly.
(2) Check the malfunction indicator light does not illuminate.
2) Warm up the engine.
3) Stop the engine, and turn the ignition switch to OFF.
4) Remove the V-belt covers.

Factory service manual diagram




5) Disconnect the ground cable from battery.

Factory service manual diagram




6) Remove the air intake duct (Rear).
7) Remove the air cleaner case.
8) Connect the timing light to the power wire of #1 ignition coil.
9) Install the air cleaner case.
10) Connect the battery ground terminal.

Factory service manual diagram




11) Start the engine, turn the timing light to the crank pulley, and check the ignition timing through the chain cover timing gauge (A).

NOTE:
If the ignition timing is not correct, check the ignition control system.

Ignition timing [BTDC/rpm]:
Standard
16°±10°/675 (AT model)
16°±10°/650 (MT model)

Factory service manual diagram




12) After inspection, install the related parts in the reverse order of removal.

Tightening torque:
13 Nm (1.3 kgf-m, 9.6 ft-lb)

Factory service manual diagram



Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.