Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Subaru Forester F4-2.5L DOHCFACTORY OEM SERVICE PROCEDURE
Engine Controls - Erroneous DTC P0108 Set
NUMBER: 11-109-11
DATE: 11/04/11
APPLICABILITY:
2011 Forester 2.5L N/A
SUBJECT:
DTC P0108 (Manifold Absolute Pressure/
Barometric Pressure Circuit High Input)
INTRODUCTION
There is a possibility that P0108 can be erroneously stored in memory when the starter motor is stopped before the engine starts completely. This can occur if the ignition key is released before the engine fully starts or if the clutch pedal is released before the engine fully starts If you determine that the code was set in error, new ECM reprogramming tiles are now available to prevent a recurrence of the condition.
COUNTERMEASURE IN PRODUCTION
The new logic was introduced in production on August 3, 2011 starting with VIN B*782579
NOTE:
LCM reprogramming files were sent to all SDS users in the October 2011 SSMIII Update version 128.427.

Pack File Applicability

Disclaimer
DATE: 11/04/11
APPLICABILITY:
2011 Forester 2.5L N/A
SUBJECT:
DTC P0108 (Manifold Absolute Pressure/
Barometric Pressure Circuit High Input)
INTRODUCTION
There is a possibility that P0108 can be erroneously stored in memory when the starter motor is stopped before the engine starts completely. This can occur if the ignition key is released before the engine fully starts or if the clutch pedal is released before the engine fully starts If you determine that the code was set in error, new ECM reprogramming tiles are now available to prevent a recurrence of the condition.
COUNTERMEASURE IN PRODUCTION
The new logic was introduced in production on August 3, 2011 starting with VIN B*782579
NOTE:
LCM reprogramming files were sent to all SDS users in the October 2011 SSMIII Update version 128.427.
Pack File Applicability
Disclaimer
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
