2011 Subaru Forester F4-2.5L DOHCFACTORY OEM SERVICE PROCEDURE

Engine Controls - DTC P2610 Stored In ECM

NUMBER: 11-105-11
DATE: 11/01/11

APPLICABILITY:
2011 Forester 2.5L N/A

SUBJECT:
DTC P2610 ECM/PCM (Internal Engine off Timer Performance)

INTRODUCTION

There is the possibility that DTC P2610 can be stored in memory if the vehicle experiences 2 consecutive occurrences where the engine is run for a period of less than 15 seconds followed immediately by a more than 5 hour soak. As an example, the car is started, backed out of a garage and then shut off (in less than 15 seconds). The car is then left sitting for more than 5 hours, started and returned to the garage (again, in less than 15 seconds) The vehicle is then left to soak overnight before the next run cycle.

In this situation, ECM replacement is not required as indicated in the service manual Reprogramming files are now available to remedy the condition.

Note:
ECM reprogramming files were sent to all SDS users in the October 2011 SSMIII Update version 1.28.42.7.

Factory service manual diagram




PACK FILE APPLICABILITY

Factory service manual diagram




Disclaimer
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.