2010 Subaru Tribeca LimitedFACTORY OEM SERVICE PROCEDURE

General Information: Notices: Note: Towing

Avoid towing vehicles except when the vehicle cannot be driven. For models with AWD, AT or VTD, use a loader instead of towing. When towing other vehicles, pay attention to the following to prevent hook or vehicle damage resulting from excessive weight.

  • Do not tow other vehicles with a front tie-down hook.
  • Make sure the vehicle towing is heavier than the vehicle being towed.
  • Remove the hook cover, and then install the hook.
    CAUTION:
    • Pull the screwdriver which is inserted into the hook cover.
    • Do not remove the hook cover holding the slit of the hook cover.
      Fig 1: Identifying Hook Cover And Hook
      G06341704Courtesy of SUBARU OF AMERICA, INC.
  • NOTES
    TOWING PRECAUTIONS

    Towing Precautions AT
    Lifting up four wheels (On a trailer)
    G05667423Courtesy of SUBARU OF AMERICA, INC.
    Towing the vehicle after lifting up all four wheels is a basic rule for AWD model. β—¦
    Rope
    G05667424Courtesy of SUBARU OF AMERICA, INC.
    • Check if both front and rear wheels are rotated normally.
    • Driving speed 30 km/h (19 MPH) or less

    Allow driving distance 50 km (31 miles) or less
    Ξ”
    Raising the front wheels
    G05667425Courtesy of SUBARU OF AMERICA, INC.
    Prohibition X
    Lifting up the front wheels
    G05664774Courtesy of SUBARU OF AMERICA, INC.
    • Prohibited, due to damage on bumper, front grille, etc.
    • Do not raise the vehicle with bumper.
    X
    Marked β—¦: OK, Marked X : Prohibited, Marked Ξ” : Conditionally OK.
    CAUTION:
    • Check ATF, gear oil and rear differential oil before driving.
    • Place the shift lever in "N" position during towing.
    • Do not lift up the rear wheels to avoid unsteady rotation.
    • Turn the ignition key to "ACC", then check the steering wheel moves freely.
    • Release the parking brake to avoid tire dragging.
    • Since the power steering does not work, be careful for the heavy steering effort. (When engine is stopped)
    • Since the servo brake does not work, be careful that the brake is not applied effectively. (When engine is stopped)
    • In case of the malfunction of internal transmission or drive system, lift up four wheels (on a trailer) for towing.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.