Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2010 Subaru Outback RFACTORY OEM SERVICE PROCEDURE
Drive Plate: Installation
- Temporarily tighten the drive plate.
- Using the ST, lock the crankshaft.
ST 498497100 CRANKSHAFT STOPPER
- Tighten the drive plate mounting bolt.NOTE: Tighten the drive plate mounting bolts gradually. Each bolt should be tightened in a crisscross order.
Tightening torque:
90 N.m (9.2 kgf-m, 66.4 ft-lb)
- Install the transmission assembly to the vehicle. Ref. to INSTALLATION , Automatic Transmission Assembly.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.