2010 Subaru Outback LimitedFACTORY OEM SERVICE PROCEDURE

Transmission Case: Assembly

  1. Using the ST, install the oil seal.

    ST 18657AA000 INSTALLER

    Fig 1: Locating Oil Seal
    G06654632Courtesy of SUBARU OF AMERICA, INC.
  2. Using ST1 and ST2, install the ball bearing on the reduction gear side.
    NOTE: Use a new ball bearing.

    ST1 398177700 INSTALLER

    ST2 499755602 PRESS SNAP RING

    Fig 2: Identifying ST1 398177700 Installer And ST2 499755602 Press Snap Ring
    G06654639Courtesy of SUBARU OF AMERICA, INC.
  3. Using ST1 and ST2, install the roller bearing on primary pulley side.
    NOTE:
    • Use a new roller bearing.
    • Make adjustment so that PRESS gets in contact with the center of ST2.

    ST1 398177700 INSTALLER

    ST2 20299AG010 PRESS SNAP RING

    Fig 3: Identifying ST1 398177700 Installer And ST2 20299AG010 Press Snap Ring
    G06654640Courtesy of SUBARU OF AMERICA, INC.
  4. Install the snap ring on primary pulley side.
    NOTE: Use new snap rings.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.