Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2010 Subaru Outback F4-2.5L SOHCFACTORY OEM SERVICE PROCEDURE
System Specifications
Cylinder Head Bolts

First pass 29 Nm (3.0 kgf-m, 21.4 ft-lb)
Second pass 69 Nm (7.0 kgf-m, 50.9 ft-lb)
Third pass: Loosen all bolts 180°
Fourth pass: Loosen all bolts 180°
Fifth pass 42 Nm (4.3 kgf-m, 31.0 ft-lb)
Sixth pass: Tighten 80-90°
Seventh pass: Tighten 40-45°
Final pass: Tighten bolts (a) and (b) 40-45°
Cylinder Head Inspection
Warping limit 0.035 mm (0.0014 in)
Grinding limit 0.1 mm (0.004 in)
Standard height of cylinder head 97.5 mm (3.84 in)
Camshaft Bearing Cap Bolts
Camshaft Sprocket Bolts 78 Nm (8.0 kgf-m, 57.5 ft-lb)
Front Exhaust Pipe to Cylinder Head Nuts 30 Nm (3.1 kgf-m, 22.1 ft-lb)
First pass 29 Nm (3.0 kgf-m, 21.4 ft-lb)
Second pass 69 Nm (7.0 kgf-m, 50.9 ft-lb)
Third pass: Loosen all bolts 180°
Fourth pass: Loosen all bolts 180°
Fifth pass 42 Nm (4.3 kgf-m, 31.0 ft-lb)
Sixth pass: Tighten 80-90°
Seventh pass: Tighten 40-45°
Final pass: Tighten bolts (a) and (b) 40-45°
Cylinder Head Inspection
Warping limit 0.035 mm (0.0014 in)
Grinding limit 0.1 mm (0.004 in)
Standard height of cylinder head 97.5 mm (3.84 in)
Camshaft Bearing Cap Bolts
Camshaft Sprocket Bolts 78 Nm (8.0 kgf-m, 57.5 ft-lb)
Front Exhaust Pipe to Cylinder Head Nuts 30 Nm (3.1 kgf-m, 22.1 ft-lb)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
