Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2010 Subaru Outback F4-2.5L SOHCFACTORY OEM SERVICE PROCEDURE
Pinout Values and Diagnostic Parameters
Engine Control Module (ECM) I/O Signal
ELECTRICAL SPECIFICATION




Input/output name:
- Crankshaft position sensor
- Camshaft position sensor
Measuring condition:
- After warming-up
- At idling






ELECTRICAL SPECIFICATION
Engine Control Module (ECM) I/O Signal (Part 1):
Engine Control Module (ECM) I/O Signal (Part 2):
Engine Control Module (ECM) I/O Signal (Part 3):
Engine Control Module (ECM) I/O Signal (Part 4):
Input/output name:
- Crankshaft position sensor
- Camshaft position sensor
Measuring condition:
- After warming-up
- At idling
Engine Control Module (ECM) I/O Signal (Part 5):
Engine Control Module (ECM) I/O Signal (Part 6):
Engine Control Module (ECM) I/O Signal (Part 7):
Engine Control Module (ECM) I/O Signal (Part 8):
Engine Control Module (ECM) I/O Signal (Part 9):
Engine Control Module (ECM) I/O Signal (Part 10):
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
