Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2010 Subaru Outback F4-2.5L SOHCFACTORY OEM SERVICE PROCEDURE
Engine Controls - Long Crank Time To Start
NUMBER: 11-95-10
DATE: 02/12/10
APPLICABILITY:
2010MY Legacy and Outback 2.5L NA, CVT
SUBJECT:
ECM Reprogramming Files for Long Cranking Condition
Introduction
This is to announce that ECM reprogramming files are now available to improve a long cranking condition that may occur in temperatures ranging from approximately 15° ~ 40° F.
Countermeasure in Production
The new logic was used in production starting the week of February 8, 2010.

PACK FILE APPLICABILITY

Disclaimer
DATE: 02/12/10
APPLICABILITY:
2010MY Legacy and Outback 2.5L NA, CVT
SUBJECT:
ECM Reprogramming Files for Long Cranking Condition
Introduction
This is to announce that ECM reprogramming files are now available to improve a long cranking condition that may occur in temperatures ranging from approximately 15° ~ 40° F.
Countermeasure in Production
The new logic was used in production starting the week of February 8, 2010.
PACK FILE APPLICABILITY
Disclaimer
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
