Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2010 Subaru Outback F4-2.5L SOHCFACTORY OEM SERVICE PROCEDURE
Keyless Entry Transmitter: Service and Repair
Keyless Transmitter
REMOVAL
1. KEYLESS TRANSMITTER BATTERY
CAUTION: To prevent static electricity damage to the keyless transmitter printed circuit board, touch the steel area of building with hand to discharge static electricity carried on body or clothes before disassembling the keyless transmitter.
Remove the screw from the keyless transmitter, then remove the keyless transmitter battery.

INSTALLATION
1. KEYLESS TRANSMITTER BATTERY
Install each part in the reverse order of removal.
REMOVAL
1. KEYLESS TRANSMITTER BATTERY
CAUTION: To prevent static electricity damage to the keyless transmitter printed circuit board, touch the steel area of building with hand to discharge static electricity carried on body or clothes before disassembling the keyless transmitter.
Remove the screw from the keyless transmitter, then remove the keyless transmitter battery.
INSTALLATION
1. KEYLESS TRANSMITTER BATTERY
Install each part in the reverse order of removal.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
