2010 Subaru Forester X, AutomaticFACTORY OEM SERVICE PROCEDURE

Select Cable: Installation

  1. Install the select cable to plate assembly.

    2. Tightening torque: 18 N.m (1.8 kgf-m, 13.3 ft-lb) 

    Fig 1: Identifying Select Cable And Plate Assembly
    G05019691Courtesy of SUBARU OF AMERICA, INC.
  2. Install the select cable to the shifter arm.
  3. Install the plate assembly to transmission.

    4. Tightening torque: 

    T: 25 N.m (2.5 kgf-m, 18.4 ft-lb) 

    Fig 2: Identifying Plate Assembly And Select Cable
    G05955814Courtesy of SUBARU OF AMERICA, INC.
  4. Install the washer and snap pin to the shifter arm.
    5. Fig 3: Identifying Washer And Snap Pin To Shifter Arm
    G05955815Courtesy of SUBARU OF AMERICA, INC.
  5. Install new clamp paying attention to the installing direction.
    6. Fig 4: Identifying Clamp Installation Position
    G05955816Courtesy of SUBARU OF AMERICA, INC.
  6. Insert the tip of inner cable into connector hole of select lever, and fix the cable to bracket.
    7. Fig 5: Fixing Cable To Bracket
    G05661218Courtesy of SUBARU OF AMERICA, INC.
  7. Shift the select lever to the "N" range, and adjust the select cable position. Refer to ADJUSTMENT , Select Cable.
  8. Install the heat shield cover.
    9. Fig 6: Identifying Heat Shield Cover
    G05661183Courtesy of SUBARU OF AMERICA, INC.
  9. Install the front, center and rear exhaust pipes, and the muffler. (Non-turbo model)

    10. Refer to INSTALLATION , Front Exhaust Pipe. Refer to INSTALLATION , Rear Exhaust Pipe. Refer to INSTALLATION , Muffler.

  10. Install the center, rear exhaust pipes and the muffler. (Turbo model)

Refer to INSTALLATION , Center Exhaust Pipe. Refer to INSTALLATION , Rear Exhaust Pipe. Refer to INSTALLATION , Muffler.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.