Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Select Cable: Installation
- Install the select cable to plate assembly.
Tightening torque:
T: 18 N.m (1.8 kgf-m, 13.3 ft-lb)
- Install the select cable to range select lever.
- Install the plate assembly to transmission.
Tightening torque:
24.5 N.m (2.5 kgf-m, 18.1 ft-lb)
- Install the washer and snap pin to range select lever.
- Install new clamp paying attention to the installing direction.
- Insert the tip of inner cable into connector hole of select lever, and fix the cable to bracket.
- Shift the select lever to the "N" range, and then adjust the select cable position. Ref. to ADJUSTMENT , Select Cable.
- Install the heat shield cover.
- Install the front exhaust pipe, rear exhaust pipe and muffler. Ref. to INSTALLATION , Front Exhaust Pipe. Ref. to INSTALLATION , Rear Exhaust Pipe. Ref. to INSTALLATION , Muffler.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.