Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Subaru Tribeca BaseFACTORY OEM SERVICE PROCEDURE
Selector Position
SELECTOR POSITION SPECIFICATION CHART
| P (Park) | Transmission is in neutral, output member is immovable, engine start is possible |
| R (Reverse) | Transmission in reverse for backing |
| N (Neutral) | Transmission is in neutral and engine start is possible |
| D (Drive) | Automatic gear change 1st ↔ 2nd ↔ 3rd ↔ 4th ↔ 5th |
| Manual mode (+) | Manual gear change 1st ↔ 2nd ↔ 3rd ↔ 4th ↔ 5th |
| Manual mode (-) | Manual gear change 1st ↔ 2nd ↔ 3rd ↔ 4th ↔ 5th |
| Control method | Wire cable type |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.