2009 Subaru Tribeca BaseFACTORY OEM SERVICE PROCEDURE

Front Vehicle Speed Sensor: Installation

  1. Install the front vehicle speed sensor.

    Tightening torque: 

    7 N.m (0.7 kgf-m, 5.2 ft-lb) 

    Fig 1: Identifying Front Vehicle Speed Sensor Securing Bolt
    G05022241Courtesy of SUBARU OF AMERICA, INC.
  2. Connect the front vehicle speed sensor connector.
    Fig 2: Identifying Front Vehicle Speed Sensor Connector
    G05668774Courtesy of SUBARU OF AMERICA, INC.
  3. Apply proper amount of liquid gasket to the entire oil pan mating surface.

    Liquid gasket: 

    THREE BOND 1217B (Part No. K0877YA020) or equivalent 

    Fig 3: Identifying Liquid Gasket Applying Area
    G05022243Courtesy of SUBARU OF AMERICA, INC.
  4. Install the oil pan by equally tightening the bolts.

    Tightening torque: 

    5 N.m (0.5 kgf-m, 3.7 ft-lb) 

  5. Install the center differential carrier. Ref. to INSTALLATION , Center Differential Carrier.
  6. Install the extension case.

    Tightening torque: 

    25 N.m (2.5 kgf-m, 18.4 ft-lb) 

    Fig 4: Identifying Extension Case
    G05022239Courtesy of SUBARU OF AMERICA, INC.
  7. Connect the rear vehicle speed sensor connector.
    Fig 5: Identifying Rear Vehicle Speed Sensor Connector
    G05668772Courtesy of SUBARU OF AMERICA, INC.
  8. Install the transmission assembly to the vehicle. Ref. to INSTALLATION , Automatic Transmission Assembly.
  9. Pour ATF from the oil charge pipe. Ref. to REPLACEMENT , Automatic Transmission Fluid.
  10. Check the level and leaks of ATF. Ref. to INSPECTION , Automatic Transmission Fluid.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.