Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Subaru Tribeca BaseFACTORY OEM SERVICE PROCEDURE
SUBARU Select Monitor (Normal Mode)
- On the «Main Menu», select {Each System Check}.
- On the «System Selection Menu», select {Engine Control System}.
- Click the [OK] key after the information regarding engine type has been displayed.
- On the «Engine Diagnosis» display screen, select {Diagnostic Code(s) Display}.
- On the «Diagnostic Trouble Code» screen, select {Temporary Diagnostic Code(s)} or {Memorized Diagnostic Code(s)}.NOTE:
- For detailed operation procedure, refer to SUBARU SELECT MONITOR .
- For details concerning DTC, refer to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.