Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Subaru Tribeca BaseFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Switches
SWITCHES LOCATION
| Component | Location |
|---|---|
| Brake Fluid Level Switch (B16) | In brake master cylinder. See Figure. |
| Buckle Switch (AB51) | Driver's seat belt buckle. See Figure. |
| Evaporation Thermo Switch (B88) | Right side of dash. See Figure. |
| Front Door Switch (Left) (R9) | Left "B" pillar. See Figure. |
| Front Door Switch (Right) (R12) | Right "B" pillar. See Figure. |
| Front Seat Belt Switch (Left) (R8) | Under driver's seat. See Figure. |
| Hood Switch (B329) | Right front of engine compartment. See Figure. |
| Oil Pressure Switch (E11) | Right front of engine. See Figure. |
| Parking Brake Switch (B404) | On parking brake assembly. See Figure. |
| Power Steering Oil Pressure Switch (E19) | Power steering oil pump. See Figure. |
| Pressure Switch (B10) | Left side of engine compartment. See Figure. |
| Rear Differential Oil Temperature Switch (R234) | At rear differential. See Figure. |
| Rear Door Switch (Left) (R22) | Left "C" pillar. See Figure. |
| Rear Door Switch (Right) (R16) | Right "C" pillar. See Figure. |
| Stoplight & Brake Switch (B65) | Left side of dash. See Figure. |
| Thermo Switch (R234) | At rear differential. See Figure. |
| Variable Valve Lift Diagnosis Oil Pressure Switch (Left) (E72) | Left rear of engine. See Figure. |
| Variable Valve Lift Diagnosis Oil Pressure Switch (Right) (E71) | Right rear of engine. See Figure. |
| Washer Level Switch (B146) | In washer reservoir. See Figure. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
