2009 Subaru Outback XT Limited, AutomaticFACTORY OEM SERVICE PROCEDURE

Read Freeze Frame Data For Engine (OBD Mode)

  1. On the «Main Menu» display screen, select the {Each System Check}.
  2. On the «System Selection Menu» display screen, select the {Engine Control System}.
  3. Click the [OK] button after the information of engine type has been displayed.
  4. On the «Engine Diagnosis» display screen, select the {OBD System}.
  5. On the «OBD Menu» display screen, select the {Freeze Frame Data Display}.
  • A list of the support data is shown in the following table.
    SUPPORT DATA REFERENCE CHART

    Contents Display Unit of measure
    DTC of freeze frame data Freeze frame data DTC
    Air fuel ratio control system for bank 1 Fuel system for Bank 1 -
    Engine load data Calculated load value %
    Engine coolant temperature signal Coolant Temp. °C or °F
    Short term fuel trim by front oxygen (A/F) sensor (Bank 1) Short term fuel trim B1 %
    Long term fuel trim by front oxygen (A/F) sensor (Bank 1) Long term fuel trim B1 %
    Intake manifold absolute pressure signal Mani. Absolute Pressure mmHg, kPa, inHg or psi
    Engine speed signal Engine Speed RPM
    Vehicle speed signal Vehicle Speed km/h or MPH
    Ignition timing adv. #1 Ignition timing adv. #1 °
    Intake air temperature Intake Air Temp. °C
    Amount of intake air Mass Air Flow g/s
    Throttle opening angle Throttle Opening Angle %
    Secondary air control status Secondary air system -
    Oxygen sensor #12 Oxygen sensor #12 V
    A/F correction #12 Short term fuel trim #12 %
    OBD system OBD System -
    Oxygen sensor #11 Oxygen sensor #11 Support
    Oxygen sensor #12 Oxygen sensor #12 Support
    Elapsed time after starting the engine Time Since Engine Start sec
    Evaporative purge Commanded EVAP Purge %
    Fuel level Fuel Level %
    Tank pressure Fuel Tank Pressure mmHg, kPa, inHg or psig
    Atmospheric pressure Atmosphere Pressure mmHg, kPa, inHg or psig
    ECM power supply voltage Control module voltage V
    Absolute load Absolute Load Value %
    A/F target lambda Target Equivalence Ratio -
    Relative throttle opening angle Relative Throttle Pos. %
    Ambient temperature Ambient Temperature °C or °F
    Absolute throttle opening angle 2 Absolute Throttle Pos.#2 %
    Absolute accelerator opening angle 1 Accelerator Pedal Pos.#1 %
    Absolute accelerator opening angle 2 Accelerator Pedal Pos.#2 %
    Target throttle opening angle Target Throt. Act. Cont. %
    NOTE: For detailed operation procedures, refer to the "SUBARU SELECT MONITOR ".
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.