2009 Subaru Outback LimitedFACTORY OEM SERVICE PROCEDURE

Transmission Control Device: Removal

  1. Remove the transmission assembly from vehicle body. Refer to REMOVAL , Automatic Transmission Assembly.
  2. Pull out the torque converter clutch assembly. Refer to REMOVAL , Torque Converter Clutch Assembly.
  3. Remove the input shaft.
  4. Lift up the lever on the rear side of transmission harness connector, and then remove it from the stay.
  5. Disconnect the air breather hose. Refer to REMOVAL , Air Breather Hose.
  6. Remove the inhibitor switch connector from the stay.
  7. Wrap vinyl tape around the nipple attached to the air breather hose.
  8. Remove the pitching stopper bracket.
  9. Remove the inhibitor switch. Refer to REMOVAL , Inhibitor Switch.
  10. Remove the control valve body assembly. Refer to REMOVAL , Control Valve Body.
  11. Pull out the straight pin of manual plate.
    Fig 1: Identifying Straight Pin Of Manual Plate
    G05956286Courtesy of SUBARU OF AMERICA, INC.
  12. Remove the bolts securing select lever, and then remove the select lever, manual plate and parking rod.
    NOTE: Be careful not to damage the lips of press-fitted oil seal in the case.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.