Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Subaru Outback LimitedFACTORY OEM SERVICE PROCEDURE
SUBARU Select Monitor (OBD Mode)
- On the «Main Menu» display screen, select the {Each System Check}.
- On the «System Selection Menu» display screen, select the {Engine Control System}.
- Click the [OK] button after the information of engine type has been displayed.
- On the «Engine Diagnosis» display screen, select the {OBD System}.
- On the «OBD Menu» display screen, select the {Clear Diagnostic Code}.
- When the "Clear Diagnostic Code?" is shown on the screen, click the [Yes] button.
- When "Done" and "Turn off the ignition switch." are shown on the display screen, turn the ignition switch to OFF.NOTE:
- Initial diagnosis of electronic throttle control is performed after memory clearance. Wait for 10 seconds or more after turning the ignition switch to ON, and then start the engine.
- For detailed operation procedures, refer to the "SUBARU SELECT MONITOR ".
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.