Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Subaru Outback LimitedFACTORY OEM SERVICE PROCEDURE
Vehicle Dynamics Control (VDC): General Description: Specification
GENERAL SPECIFICATION
| Item | Specification or identification | |||
|---|---|---|---|---|
| ABS wheel speed sensor | ABS wheel speed sensor gap (for reference) | Front | 0.77 - 1.43 mm (0.030 - 0.056 in) | |
| Rear | 0.64 - 1.56 mm (0.025 - 0.061 in) | |||
| Identifications of harness (marks, color) | Front | RH | K1 (White) | |
| LH | K2 (Yellow) | |||
| Rear | RH | K5 (White) | ||
| LH | K6 (Yellow) | |||
| VDCCM&H/U Identification | AT: 2.5GT SED, OBK 2.5XT, OBK 3.0R | T3 | ||
| AT: 3.0R (18 inch tire) | T7 | |||
| AT: OBK 2.5i, 2.5i SED, 3.0R (17 inch tire) | TA | |||
| MT: 2.5GT-B, OBK 2.5XT | T4 | |||
| MT: OBK 2.5i, 2.5i SED | TB | |||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.