2009 Subaru Outback F6-3.0L DOHCFACTORY OEM SERVICE PROCEDURE

Tightening Torques

Cylinder head bolts Specifications

Camshaft caps
(1) - (12) 16 N-m (1) 6 kgf-m, 11.8 ft-lb)
(13) - (16) 9.75 N-m (1) 0 kgf-m, 7.2 ft-lb)

Factory service manual diagram




Cylinder block connecting bolts
(1) - (11), (13) 25 N-m (2.5 kgf-m, 18.4 ft-lb)
(12), (14) 20 N-m (2.0 kgf-m, 14.8 ft-lb)

Factory service manual diagram




Retighten
(1) - (11), (13) 25 N-m (2.5 kgf-m, 18.4 ft-lb)
(12), (14) 20 N-m (2.0 kgf-m, 14.8 ft-lb)

Factory service manual diagram




Tighten all bolts further 90 degrees - 110 degrees

Factory service manual diagram




Upper bolt to cylinder block 25 N-m (2.5 kgf-m, 18.4 ft-lb)

Connecting rod bolt 53 Nm (5.4 kgf-m, 39.1 ft lb)

Drive plate 81 Nm (8.3 kgf-m, 59.7 ft lb)

Oil pump 6.4 N-m (0. 7 kgf-m, 4.7 ft-lb)

Factory service manual diagram




Water pump 6.4 N-m (0. 7 kgf-m, 4.7 ft-lb)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.