Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Subaru Legacy RFACTORY OEM SERVICE PROCEDURE
Preparation For Learning Control
- Warm-up or cool down until the ATF temperature displayed on the Subaru Select Monitor reaches 60 - 80°C (140 - 176°F).
- Shift the select lever to "P" range.
- Fully apply the parking brake.
- Lift up the vehicle.CAUTION: Be sure to keep the lowest edge of the tires 30 cm or more off the ground because the vehicle vibrates during the work.
- Connect the Subaru Select Monitor to the data link connector.
- Turn the ignition switch to ON. (Press push button ignition switch twice without depressing brake pedal for push button start.)
- Select {Learning and inspection mode related to AT} on the «Transmission Diagnosis» display screen of Subaru Select Monitor.
- Select {AT learning mode} on the «Learning and inspection mode related to AT» display screen of Subaru Select Monitor.
- Perform the procedures according to the message displayed on the Subaru Select Monitor.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
