Name: AllOEMManuals
Address: 316 Brandywine Ave, Streetman, TX, 75859, US
Telephone: +14699867883
Price range: $$

Clean all the parts before assembly.
Apply NIGTIGHT LYW No. 2 grease or equivalent to each part. < Ref. to AT SELECT LEVER , COMPONENT, General Description . >
Assemble in the reverse order of disassembly.
NOTE:
- Refer to "COMPONENT" for each tightening torque. < Ref. to AT SELECT LEVER , COMPONENT, General Description . >
- When pressing in the shift position pin, insert from the left side of the vehicle.
- Affix the harness of the shift button switch and the mode change switch at the marked positions.
  
  Fig 1: Locating Harness Of Shift Button Switch
  Courtesy of SUBARU OF AMERICA, INC.
- Connect the terminals of all switches to the respective connectors.
  
  Fig 2: Identifying Connector Terminal Locations
  Courtesy of SUBARU OF AMERICA, INC.
After completing installation, shift the select lever from the "P" range to the "D" range, then check whether or not the selection indicator in the combination meter and the select lever position matches. Also check whether the pointer and position mark matches, and what the operating force is.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Select Lever: Assembly