Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Subaru Tribeca BaseFACTORY OEM SERVICE PROCEDURE
SUBARU Select Monitor (Normal Mode)
- On the « Main Menu » display screen, select the {Each System Check}.
- On the « System Selection Menu » display screen, select the {Engine Control System}.
- Click the [OK] button after the information of engine type has been displayed.
- On the « Engine Diagnosis » display screen, select the {Diagnostic Code(s) Display}.
- On the « Diagnostic Trouble Code » screen, select {Temporary Code} or {Memory Code}.NOTE:
- For detailed operation procedure, refer to the "PC application help for Subaru Select Monitor".
- For details concerning DTC, refer to "LIST OF DIAGNOSTIC TROUBLE CODE (DTC) ".
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.