2008 Subaru Tribeca BaseFACTORY OEM SERVICE PROCEDURE

Fuel Tank: Installation

  1. Install the fuel tank to the vehicle.
    WARNING: A helper is required to perform this work.
    1. Lift the fuel tank with the transmission jack.
    2. Mount the fuel tank to the vehicle with a jack.
    3. Install the fuel tank band that holds the fuel tank.

      Tightening torque: 

      33 N.m (3.4 kgf-m, 24.3 ft-lb) 

      Fig 1: Locating Fuel Tank Band
      G05667640Courtesy of SUBARU OF AMERICA, INC.
  2. Connect evaporation hose (A), connector (B) and fuel filler hose (C).
    Fig 2: Identifying Connector With Evaporation And Fuel Filler Hose
    G05345616Courtesy of SUBARU OF AMERICA, INC.
  3. Install the rear suspension assembly. <Ref. to INSTALLATION , Rear Sub Frame.>
  4. Install the clip that holds the harness.
    Fig 3: Locating Clip Holding Harness
    G05031087Courtesy of SUBARU OF AMERICA, INC.
  5. Lower the vehicle.
  6. Install the rear wheels.

    Tightening torque: 

    Chrome plated wheel 

    150 N.m (15.3 kgf-m, 110.6 ft-lb) 

    Other than above 

    120 N.m (12.2 kgf-m, 88.5 ft-lb) 

  7. Connect the quick connector on fuel delivery hose. <Ref. to INSTALLATION , Fuel Delivery & Evaporation Lines.>
  8. Install the service hole cover of fuel sub level sensor.
    Fig 4: Locating Service Hole Cover Bolts
    G05031085Courtesy of SUBARU OF AMERICA, INC.
  9. Install the service hole cover of fuel pump.
    1. Push on the grommet (B) to install it to the service hole cover.
    2. Tighten the bolt (A).
    3. Connect the connector (C).
      Fig 5: Identifying Grommet, Bolt And Connector
      G05345612Courtesy of SUBARU OF AMERICA, INC.
  10. Install the second seat. <Ref. to INSTALLATION , Second Seat.>
  11. Install the fuse of fuel pump to the main fuse box.
  12. Connect the battery ground cable to the battery.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.