2008 Subaru Tribeca BaseFACTORY OEM SERVICE PROCEDURE

LH Side

  1. Remove the collector cover.
  2. Release the fuel pressure. <Ref. to RELEASING OF FUEL PRESSURE , PROCEDURE, Fuel.>
  3. Remove the battery.
  4. Open the fuel filler flap lid, and remove the fuel filler cap.
  5. Remove the generator harness from the fuel pipe protector LH.
  6. Remove the fuel pipe protector LH.
    Fig 1: Locating Fuel Pipe Protector Bolts (LH)
    G05018408Courtesy of SUBARU OF AMERICA, INC.
  7. Disconnect the connector from fuel injector.
  8. Remove the engine harness from the fuel injector pipe LH.
  9. Remove the bolts which hold fuel injector pipe onto cylinder head.
    Fig 2: Locating Bolts Holding Fuel Injector Pipe Onto Cylinder Head (LH)
    G05667597Courtesy of SUBARU OF AMERICA, INC.
  10. Remove the fuel injector while lifting up the fuel injector pipe.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.