2008 Subaru Tribeca BaseFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Grounds

GROUNDS LOCATION

Component Location
BAT-1 At battery. See Figure.
GB-1 Right front of engine compartment. See Figure.
GB-2 Left front of engine compartment. See Figure.
GB-3 Behind center of dash. See Figure.
GB-4 Behind left kick panel. See Figure.
GB-5 Behind right end of dash. See Figure.
GB-6 Behind center of dash. See Figure.
GB-7 Behind right kick panel. See Figure.
GB-8 Under front passenger seat. See Figure.
GB-9 At right "C" pillar. See Figure.
GB-10 At right "D" pillar. See Figure.
GB-11 Under center console. See Figure.
GB-12 At left "D" pillar. See Figure.
GB-13 At left "C" pillar. See Figure.
GB-15 Top right "D" pillar. See Figure.
GE Left rear of engine. See Figure.
GR Under center of dash. See Figure.
GV Right side of engine compartment. See Figure.
R277 (Rear Differential Gear Oil Temperature Switch Bracket Earth) At rear differential. See Figure.
R288 (Rear View Camera Ground) Left rear of vehicle. See Figure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.