Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2008 Subaru Tribeca BaseFACTORY OEM SERVICE PROCEDURE

Outer Mirror: Replacement

Face the mirror upward.
Use a flat tip screwdriver to remove clip (A).
Lift the lower mirror up to remove hooks (B).

Fig 1: Identifying Outer Mirror Clip
Courtesy of SUBARU OF AMERICA, INC.
Disconnect the mirror heater connector from side of the mirror. (Model with mirror heater)

Fig 2: Identifying Mirror Heater Connector
Courtesy of SUBARU OF AMERICA, INC.
Catch the hooks (B) and install clips (A).

Fig 3: Identifying Hooks And Clips
Courtesy of SUBARU OF AMERICA, INC.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.