Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Subaru Outback F4-2.5L SOHCFACTORY OEM SERVICE PROCEDURE
System Specifications
Cylinder head
Surface warpage limit 0.035 mm (0.0014 in)
Tightening Torque
Tighten all bolts to 29 N-m (3.0 kgf-m, 21.4 ft-lb) in alphabetical order.
Tighten all bolts to 69 N-m (7.0 kgf-m, 50.9 ft-lb) in alphabetical order.
Loosen all the bolts by 180° in the reverse order of installing, and loosen them further by 180°.
Tighten all bolts to 42 N-m (4.3 kgf-m, 31.0 ft-lb) in alphabetical order.
Tighten all bolts by 80 to 90° in alphabetical order.
Tighten all bolts by 40 to 45° in alphabetical order.
CAUTION: The tightening angle of the bolt should not exceed 45°.
Further tighten the bolts (a) and (b) by 40 - 45°.
CAUTION: Make sure the total "re-tightening angle" does not exceed 90°.

Camshaft bearing caps


Cam Sprocket
Tightening torque 78 N-m (8.0 kgf-m, 57.5 ft-lb)
Surface warpage limit 0.035 mm (0.0014 in)
Tightening Torque
Tighten all bolts to 29 N-m (3.0 kgf-m, 21.4 ft-lb) in alphabetical order.
Tighten all bolts to 69 N-m (7.0 kgf-m, 50.9 ft-lb) in alphabetical order.
Loosen all the bolts by 180° in the reverse order of installing, and loosen them further by 180°.
Tighten all bolts to 42 N-m (4.3 kgf-m, 31.0 ft-lb) in alphabetical order.
Tighten all bolts by 80 to 90° in alphabetical order.
Tighten all bolts by 40 to 45° in alphabetical order.
CAUTION: The tightening angle of the bolt should not exceed 45°.
Further tighten the bolts (a) and (b) by 40 - 45°.
CAUTION: Make sure the total "re-tightening angle" does not exceed 90°.
Camshaft bearing caps
Cam Sprocket
Tightening torque 78 N-m (8.0 kgf-m, 57.5 ft-lb)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
