2008 Subaru Outback Base, StandardFACTORY OEM SERVICE PROCEDURE

Combination Switch (Light): Removal

WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ground cable from battery.
  2. Remove the screws and remove the steering column covers (upper and lower).
    Fig 1: Locating Steering Column Covers Screws
    G05022834
  3. Disconnect the connector from combination switch.
  4. Remove the screws which secure the switch, then remove the combination switch.
    Fig 2: Locating Combination Switch Screws
    G05022457
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.