2008 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Reverse Check Cable: Removal

  1. Set the vehicle on a lift.
  2. Remove the gear shift knob.
  3. Remove the console box front. < Ref. to REMOVAL , Console Box . >
  4. Remove the front cover assembly.
  5. Remove the spring pin from the slider.
    Fig 1: Identifying Spring Pin And Slider
    G05666242Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the slider and spring.
    Fig 2: Identifying Slider And Spring
    G05666243Courtesy of SUBARU OF AMERICA, INC.
  7. Cut the band clip, and separate the reverse check cable from the gear shift lever.
  8. Lift up the vehicle.
  9. Remove the under cover.
  10. Remove the rear exhaust pipe and muffler. < Refer to (H4DOTC) REMOVAL , Rear Exhaust Pipe. > < Refer to (H4DOTC) REMOVAL , Muffler. >
  11. Remove the crossmember. < Ref. to REMOVAL , Transmission Mounting System . >
  12. Remove the snap pin and washer, and separate the reverse check cable from the reverse check lever.
    Fig 3: Identifying Snap Pin And Washer
    G05666244Courtesy of SUBARU OF AMERICA, INC.
  13. Move the transmission to the right side, and remove the stay bolts and reverse check cable.
    NOTE: If the transmission is not moved aside, the stay bolts may contact the body and cause damage.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.