2008 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Control Valve Body: Removal

  1. Set the vehicle on a lift.
  2. Disconnect the ground cable from the battery.
  3. Lift up the vehicle.
  4. Clean the transmission exterior.
  5. Remove the drain plug (ATF) to drain the ATF.
    CAUTION: After running the engine or after idling for a long time, the ATF is hot. Be careful not to burn yourself.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.