2008 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Rear Sub Frame: Installation

  1. Install in the reverse order of removal.
  2. Follow the procedure below for the rear differential installation and tightening torque.

    T-type

    <Ref. to INSTALLATION , Rear Differential (T-type) .>

    VA-type

    <Ref. to INSTALLATION , Rear Differential (VA-type) .>

  3. Support the rear arm horizontally using a transmission jack. Tighten the nuts and bolts which hold the rear arm, front link, rear link, upper link and shock absorber.
    Fig 1: Supporting Rear Arm Using Transmission Jack
    G05342922Courtesy of SUBARU OF AMERICA, INC.

    Tightening torque: 

    Refer to "COMPONENT" of "General Description" for tightening torque. <Ref. to  REAR SUSPENSION  , COMPONENT, General Description .> 

  4. Check the wheel alignment and adjust it if necessary.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.