2008 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Front Crossmember: Installation

  1. Install in the reverse order of removal.
    NOTE:
    • Use a new bolt and self-locking nut. For parts which are not reusable, refer to "COMPONENT". <Ref. to COMPONENT , General Description .>
    • Always tighten the stabilizer bushing in the state where the vehicle is at curb weight and the wheels are in full contact with the ground.

    Tightening torque: 

    Crossmember to body: 

    95 N.m (9.7 kgf-m, 70.1 ft-lb) 

    Engine mounting to Crossmember: 

    75 N.m (7.6 kgf-m, 55.3 ft-lb) 

    Front arm to Crossmember: 

    95 N.m (9.7 kgf-m, 70.1 ft-lb) 

    Front arm to Support plate: 

    110 N.m (11.2 kgf-m, 81.1 ft-lb) 

    Support plate to Body: 

    150 N.m (15.3 kgf-m, 110.6 ft-lb) 

    Tie-rod end to Housing: 

    27.0 N.m (2.75 kgf-m, 19.9 ft-lb) 

    After tightening to the specified torque, tighten the castle nut further but within 60° until the hole in the ball stud is aligned with a slot in castle nut

    Universal joint: 

    24 N.m (2.4 kgf-m, 17.4 ft-lb) 

    Stabilizer bracket: 

    25 N.m (2.5 kgf-m, 18.1 ft-lb) 

    Stabilizer link: 

    45 N.m (4.6 kgf-m, 33.2 ft-lb) 

    Power steering hose to Steering gearbox: 

    15 N.m (1.5 kgf-m, 11 ft-lb) 

  2. Purge air from the power steering system.
  3. Inspect the wheel alignment and adjust if necessary.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.