Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Pipe Assembly: Removal
- Disconnect the ground cable from the battery.
- Lift-up the vehicle, and then remove the front crossmember support plate and jack-up plate.
- Large type
- Small type
- Remove the one pipe joint at the center of the gearbox, and connect the vinyl hose to the pipe and the joint. Discharge the fluid by turning the steering wheel fully clockwise and counterclockwise. Discharge the fluid similarly from other pipes.
- Remove the clamp E from return hose and pressure hose.
- Disconnect the pipe D from return hose and pipe C from pressure hose.
- Remove the air intake duct. <Ref. to REMOVAL , Air Intake Duct (H4DOTC).> <Ref. to REMOVAL , Air Intake Duct (H4SO).>
- Disconnect the suction hose and pressure hose from oil pump.
- Disconnect the suction hose and return hose from the reservoir tank.
- Remove the hose bracket and take out the hose assembly from vehicle.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
