Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Section 14 (Clutch System): Flywheel: Installation
WARNING: This page is about a different variant/trim than selected.
- Install the flywheel and ST.
ST 498497100 CRANKSHAFT STOPPER
- Tighten the flywheel mounting bolts to the specified torque.
ST 499057000 TORX® PLUS (Used for 5MT turbo model)
CAUTION: The bolts without identification groove as shown in the figure must be used as flywheel attaching bolts for 5MT turbo model.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
