Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Intake Manifold: Disassembly
WARNING: This page is about a different variant/trim than selected.
- Remove the engine harness from intake manifold.
- Remove the throttle body. < Ref. to REMOVAL , Throttle Body. >
- Remove the EGR valve. < Ref. to REMOVAL , EGR Valve. >
- Remove the manifold absolute pressure sensor. < Ref. to REMOVAL , Manifold Absolute Pressure Sensor. >
- Remove the purge control solenoid valve. < Ref. to REMOVAL , Purge Control Solenoid Valve. >
- Loosen the clamp which holds fuel injector pipe to the fuel hose, and then disconnect the pipe from fuel hose.
- Remove the bolts which install fuel pipes on intake manifold.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.