Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Propeller Shaft
WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
PROPELLER SHAFT SPECIFICATIONS
| Model | 5MT | 4AT | 5AT | ||
|---|---|---|---|---|---|
| Propeller shaft type | EDJ | ||||
| Propeller shaft length: L | mm (in) | 1,490 (58.66) | 1,430 (56.30) | 1,317 (51.85) | |
| Front propeller shaft Joint-to-joint length: L1 | mm (in) | 735 (28.9) | 675 (26.6) | 562 (22.1) | |
| Rear propeller shaft Joint-to-Joint length: L2 | mm (in) | 755 (29.7) | |||
| Outer diameter of tube: | mm (in) | D1 | 63.5 (2.50) | ||
| D2 | 57.5 (2.26) | ||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
