Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2008 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Section 70 (Differentials): General Description: Specifications: Classification

WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Identification label positions are shown in Fig 1, for (T-Type), Fig 2, for (VA1-Type) & Fig 3, for (VA2-Type) . For details concerning identification, refer to IDENTIFICATION , General Info.

T-type

Fig 1: Locating Identification Label Positions (T-Type)

G03832406

Courtesy of SUBARU OF AMERICA, INC.

VA1-type

Fig 2: Locating Identification Label Positions (VA1-Type)

G03832407

Courtesy of SUBARU OF AMERICA, INC.

VA2-type

Fig 3: Locating Identification Label Positions (VA2-Type)

G03832408

Courtesy of SUBARU OF AMERICA, INC.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.