2008 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Section 56 (Lighting System): General Description: Specification

WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
GENERAL SPECIFICATIONS

Headlight Halogen type low beam 12 V - 55 W
Halogen type high beam 12 V - 60 W
Front turn signal, parking, front side marker light 12 V - 27/8 W
Front fog light OUTBACK 12 V - 51 W
Except for OUTBACK 12 V - 55 W
Side turn signal light 12 V - 2.7 W (LED)
Rear combination light Stop/tail light 12 V - 21/5 W
Turn signal light 12 V - 21 W
Wagon Rear side marker light 12 V - 5 W
Back-up light Sedan 12 V - 16 W
Wagon 12 V - 16 W
License plate light 12 V - 5 W
High-mounted stop light Sedan 12 V - 21 W
Wagon 12 V - 1.3 W (LED)
Room light 12 V - 8 W
Spot map light 12 V - 8 W
Luggage room light 12 V - 13 W
Trunk room light 12 V - 5 W
Glove box light 12 V - 1.4 W
Door step light 12 V - 3.5 W
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.