Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Remote Control Mirror Switch: Inspection
WARNING: This page is about a different car, the 2008 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
Move the remote control mirror switch to each position and check continuity between terminals.
- Switch the change over switch to the right side:REMOTE CONTROL MIRROR SWITCH CONNECTOR TERMINALS SPECIFICATIONS
Switch position Terminal No. Standard OFF - 1 MΞ© or more UP 8 and 3, 6 and 7 Less than 1 Ξ© DOWN 8 and 6, 3 and 7 Less than 1 Ξ© LEFT 8 and 2, 6 and 7 Less than 1 Ξ© RIGHT 8 and 6, 2 and 7 Less than 1 Ξ© - Switch the change over switch to the left side:
CONNECTOR TERMINALS SPECIFICATIONS
| Switch position | Terminal No. | Standard |
|---|---|---|
| OFF | - | 1 MΞ© or more |
| UP | 8 and 4, 6 and 7 | Less than 1 Ξ© |
| DOWN | 8 and 6, 4 and 7 | Less than 1 Ξ© |
| LEFT | 8 and 5, 6 and 7 | Less than 1 Ξ© |
| RIGHT | 8 and 6, 5 and 7 | Less than 1 Ξ© |
If NG, replace the switch.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.