2008 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Rear Disc Brake Assembly: Installation

WARNING: This page is about a different car, the 2007 Subaru Outback and 2007 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the support on housing.

    Tightening torque: 

    53 N.m (5.4 kgf-m, 39.1 ft-lb) 

  2. Apply a thin coat of Molykote M7439 to pad clip.
    Fig 1: Locating Molykote M7439 Applying Point (Rear Disc Brake)
    G03832981Courtesy of SUBARU OF AMERICA, INC.
  3. Apply a thin coat of Molykote AS880N (Part No. K0777YA010) to the frictional portion between pad and shim.
  4. Install the pad on support.
  5. Install the caliper body on support.

    Tightening torque: 

    Solid disc brake model 

    27 N.m (2.8 kgf-m, 19.9 ft-lb) 

    Ventilated disc brake model 

    37 N.m (3.7 kgf-m, 27.2 ft-lb) 

  6. Connect the brake hose using new brake hose gaskets.

    Tightening torque: 

    18 N.m (1.8 kgf-m, 13.0 ft-lb) 

  7. Bleed air from the brake system.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.