2008 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Section 136 (Anti-Lock Brake System (Abs)): General Description: Specification

WARNING: This page is about a different car, the 2007 Subaru Outback and 2007 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
GENERAL SPECIFICATIONS

Item Specification or identification
ABS wheel speed sensor ABS wheel speed sensor gap (for reference) Front 0.77 - 1.43 mm (0.030 - 0.056 in)
Rear 0.64 - 1.56 mm (0.025 - 0.061 in)
Identifications of harness (marks, color) Front RH K1 (White)
LH K2 (Yellow)
Rear RH K5 (White)
LH K6 (Yellow)
G sensor G sensor voltage 2.3Β±0.2 V
ABSCM & H/U identification AT (Except for OUTBACK) J1
MT (Except for OUTBACK) J2
AT (OUTBACK) J3
MT (OUTBACK) J4
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.