2008 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Section 12 (Starting/Charging Systems (H4SO)): Generator: Removal

WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ground cable from battery.
    Fig 1: Disconnecting Ground Cable From Battery
    G05019586
  2. Disconnect the connector and terminal from generator.
    • 2.5 L Non-turbo model
      Fig 2: Identifying Generator Connector - 2.5 L Non-Turbo Model
      G04997958
    • 3.0 L Non-turbo model
      Fig 3: Identifying Generator Connector - 3.0 L Non-Turbo Model
      G05017447
    • Turbo model
      Fig 4: Identifying Generator Connector - Turbo Model
      G05017448
  3. Remove the V-belt covers.
  4. Remove the V-belts.

    < Ref. to FRONT SIDE BELT (H4SO) , REMOVAL, V-belt. > or < Ref. to FRONT SIDE BELT (H4DOTC) , REMOVAL, V-belt. > < Ref. to REMOVAL , V-belt. >

  5. Remove the bolts which install the generator onto bracket.
    Fig 5: Locating Generator Bolts
    G05017449
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.