2008 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Section 117 (Lighting System): General Description: Specification

WARNING: This page is about a different car, the 2007 Subaru Outback and 2007 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
LIGHT SPECIFICATION

Headlight Halogen type low beam 12 V - 55 W
Halogen type high beam 12V - 60W
Front turn signal, parking, front side marker light 12 V - 27/8 W
Front fog light OUTBACK 12V - 51 W
Except for OUTBACK 12 V - 55 W
Side turn signal light 12 V - 2.7 W (LED)
Rear combination light Stop/tail light 12 V - 21/5 W
Turn signal light 12V - 21 W
Wagon Rear side marker light 12V - 5W
Back-up light Sedan 12V - 16W
Wagon 12V - 16W
License plate light 12V - 5W
High-mounted stop light Sedan 12V - 21 W
Wagon 12 V - 1.3 W (LED)
Room light 12V - 8W
Spot map light 12V - 8W
Luggage room light 12V - 13W
Trunk room light 12V - 5W
Glove box light 12V - 1.4W
Door step light 12 V - 3.5 W
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.