Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE
How To Use The SUBARU Select Monitor
- Prepare the Subaru Select Monitor kit. <Ref. to PREPARATION TOOL , General Description .>
- Connect the diagnosis cable to the Subaru Select Monitor.
- Connect the Subaru Select Monitor to the data link connector.
- Data link connector is located in the lower portion of instrument panel (on the driver's side).
- Connect the diagnosis cable to the data link connector.CAUTION: Do not connect the scan tools except for the Subaru Select Monitor or general scan tool.
- Turn the ignition switch to ON (engine OFF) and run the Subaru Select Monitor.
- Using the Subaru Select Monitor, call up DTC and data, then record them.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.