2008 Subaru Outback Base, AutomaticFACTORY OEM SERVICE PROCEDURE

SUBARU Select Monitor (OBD Mode)

  1. On the «Main Menu» display screen, select {Each System Check}.
  2. On the «System Selection Menu» display screen, select {Engine Control System}.
  3. Select the [OK] after the information of engine type has been displayed.
  4. On the «Engine Diagnosis» display screen, select the {OBD System}.
  5. On the «OBD Menu» display screen, select {DTC Clear}.
  6. When the "Clear Diagnostic Code?" is shown on the screen, select the [OK].
  7. Turn the ignition switch to OFF and then close the Subaru Select Monitor.
    NOTE:
    • Initial diagnosis of electronic throttle control is performed after memory clearance. For this reason, start the engine after 10 seconds or more have elapsed since the ignition switch was turned to ON.
    • For detailed operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION MANUAL".
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.